ext2 files

Support section for FREESCO v0.4.x

ext2 files

Postby strampke » Fri May 09, 2014 6:07 pm

Starting 0.4.5 the ext2 check doesn't start because the necessary files are not in place
How come? What can I do to repair.

Besides: starting dhcpd - malformed entry
Where does it go wrong

Report.txt added.

One day later:
reinstalled from disk leaving old files intact and there they are, my ext2 check files

Replaced the (year 1996) 3.0V battery in the computer so that I didn't have to set time every reboot

As if a miracle occured the dhcp malformed entry warning vanished.

Happy ever after.
You do not have the required permissions to view the files attached to this post.
Who knows knows, who doesn't doesn't.
User avatar
Junior Advanced Member
Posts: 151
Joined: Mon Jul 29, 2002 12:36 pm
Location: Delden, Netherlands

Re: ext2 files

Postby Lightning » Sat May 10, 2014 11:51 am

I guess it did not get fully installed the first time, which is sort of strange. But it is not impossible to happen as the scripting is quite complex.

Just one question, have you tried the 0.4.5 "tuxhunter"?
If you are afraid that you might make a mistake. The chances are high that you will never learn anything.
User avatar
Posts: 12081
Joined: Wed Nov 14, 2001 6:50 am
Location: Oregon, USA

Return to FREESCO Support for v0.4.x

Who is online

Users browsing this forum: No registered users and 4 guests